Ceresit CT98 Impurity Remover - 5L

Ceresit CT98 Impurity Remover is a specialised cleaning solution designed to effectively remove a wide range of impurities and contaminants from various surfaces. This product is particularly well-suited for use on mineral-based substrates, such as concrete, masonry, and rendered walls, prior to the application of decorative finishes or coatings. The Ceresit CT98 is formulated to target and break down a variety of stubborn deposits, including grease, oil, soot, and other organic matter. Its powerful yet controlled cleaning action helps to restore the surface to a clean, neutral condition, ensuring optimal adhesion and performance of subsequent treatments.

When applied, the Ceresit CT98 Impurity Remover penetrates deep into the substrate, lifting and dissolving the problematic contaminants. This process leaves the surface thoroughly cleaned and prepared for the next stage of the project, whether that involves the application of a filler, primer, or final decorative coating. The product is easy to apply using a brush, roller, or sprayer, and it dries quickly, minimising downtime. It is also low in odour, making it a suitable choice for use in occupied or sensitive environments. Ceresit CT98 Impurity Remover is an essential tool for ensuring a clean, well-prepared surface before the application of any exterior finishing systems. Its effective cleaning capabilities help to maximise the performance and longevity of the overall project.

CHARACTERISTICS

• Specialised cleaning solution for mineral-based substrates
• Effectively removes a wide range of impurities and contaminants, including grease, oil, soot and organic matter
• Formulated to penetrate deep into the substrate and lift/dissolve stubborn deposits
• Restores the surface to a clean, neutral condition for optimal adhesion of subsequent treatments
• Easy to apply using a brush, roller, or sprayer
• Dries quickly, minimising downtime
• Low in odour, suitable for use in occupied or sensitive environments
• Essential for preparing surfaces before the application of exterior finishing systems
• Helps to maximise the performance and longevity of the overall project
• Suitable for use on concrete, masonry, rendered walls, and other mineral-based substrates

How to use

• Ensure the surface to be cleaned is dry and free from any loose debris or dust.
• Protect any surrounding areas or surfaces that are not intended to be cleaned.
• Ceresit CT98 Impurity Remover is a concentrated product, so it must be diluted with water before use.
• Refer to the manufacturer's instructions for the recommended dilution ratio, which is typically between 1:1 and 1:5 (CT98 concentrate to water).
• Pour the required amount of concentrate into a clean container, then slowly add the appropriate volume of clean water while stirring continuously.
• Apply the product liberally to the surface using a brush, roller, or low-pressure sprayer, ensuring even coverage.
• Allow the product to dwell on the surface for 5-10 minutes, giving it time to penetrate and break down the impurities.
• For heavily soiled or stubborn areas, use a stiff-bristled brush or abrasive pad to gently scrub the surface during the dwell time.
• This mechanical agitation can help to lift and remove more persistent contaminants.
• After the dwell time, thoroughly rinse the surface with clean water to remove any dissolved impurities and residual Ceresit CT98 solution.
• Use a low-pressure water source, such as a garden hose, to avoid damaging the substrate.
• Ensure all traces of the cleaning solution have been removed from the surface.
• Allow the cleaned surface to dry completely before proceeding with any further treatments or coatings.
• Drying time will depend on environmental conditions, but typically takes 1-2 hours.

Always follow the manufacturer's instructions and safety guidelines when using this product.