250mm Ancon Staifix HRT4 Stainless Steel Wall Tie - Masonry Light Duty Tie - Type 4 - pack of 20
250mm Ancon Staifix HRT4 Stainless Steel Wall Tie - Masonry Light Duty Tie - Type 4 - pack of 20
Price: £6.53 (£7.84 inc VAT)
- Product Code: A1-5340
- Delivery Time: 2 - 3 working days
- Brand: Ancon (Tech. support: : +44(0)1142381238)
- Model: 250mm
Our ratings on 08-11-2024:
4.8 out of 5
This product has a minimum quantity of 20. If you need less - request a quote.
Show other sizes
250mm Ancon Staifix HRT4 Stainless Steel Wall Tie - Masonry Light Duty Tie - Type 4 - pack of 20
Length: 250mm
Pack Quantity: 20
Cavity width: 101-125mm
250mm Ancon Staifix HRT4 Wall Tie is a low conductivity stainless steel masonry wall tie for use in domestic houses up to 10 metres in height. Wall ties should be pressed down in fresh mortar. They should be surrounded by mortar and they should be installed as the inner leaf is constructed and not simply pushed into a joint. Ideally, ties should be installed level or with a slight fall to the outer leaf. Ancon Staifix HRT4 wall tie should be positioned centrally as a drip will normally be near the centre of the open section of a partial fill cavity.
CHARACTERISTICS
- Masonry-to-masonry wall tie,
- For use in domestic houses up to 10 metres in height
- Light duty type 4 wall tie,
- Meets the performance requirement of Approved Document E for use in external masonry walls,
- Suitable for cavities of 101-125mm,
Brand: Ancon
Model: 250mm
Delivery Time: 2 - 3 working days
250mm AC 31 Wall Tie is a masonry remedial wall tie for tying together two leaves of solid walls, where bricks are removed then replaced in the outer leaf. The wavy end is resin-bonded into the inner leaf in a 10mm Ø hole. The triangular end sits in the bed joint. Ancon AC 31 wall tie is s..
Brand: Ancon
Model: CFS180
Delivery Time: 2 - 5 working days
Ancon CFS180 Concrete Fixing Screws is used to fix an outer leaf of brickwork through any kind of insulation to a concrete wall. These zinc plated carbon steel screws should be used in combination with Ancon Compression Sleeves in the same length as the insulation thickness being used..
Brand: Ancon
Model: 152mm
Delivery Time: 1-3 working days
152mm Ancon Staifix Timber Frame Tie is a cranked tie used to fix brickwork or blockwork to timber-framed structures up to 4 storeys in height. It is a type 6 tie that has been independently tested for use with 15mm OSB SIPS (structural insulated panel) panel. It is supplied with an annular rin..
£87.63
£105.16 inc VAT
Brand: Ancon
Model: 375mm
Delivery Time: 3 - 5 days
375mm Ancon Teplo-BF-2 Wall Tie is a smart black general purpose composite wall tie manufactured from pultruded basalt fibres with a thermal conductivity of 0.7 W/mK, which helps to prevent heat escape from the building. The Teplo-BF-2 has specialised moulded safety ends which offer improved bu..
Guide Price: £3.47
£4.16 inc VAT
Brand: Ancon
Model: 150mm
Delivery Time: 1-3 working days
150mm Super-7 Thor-Helical Nails are used to fix counter-battens to rafters, without compressing the layer of insulation in-between. Super-7 Thor-Helical Nails are manufactured from stainless steel and are engineered with the precise Thor-Helical patented helix, and provide maximum corrosion re..
£160.08
£192.10 inc VAT
Brand: Ancon
Model: CFS302
Delivery Time: 2 - 5 working days
Ancon CFS302 Concrete Fixing Screws is used to fix an outer leaf of brickwork through any kind of insulation to a concrete wall. These zinc plated carbon steel screws should be used in combination with Ancon Compression Sleeves in the same length as the insulation thickness being used..